Wood Designer forum
Automatically drilling through|Forum|WOOD DESIGNER
January 20, 2017
Hi,
From Post-Pro options, you have the option to merge two opposite drillings into single thought drilling
For some PPs that change the drill bit code to “Lancia” and have to force as a standard drill bit if you don’t have suitable drill bits.
as examples
to “Normal” for Biesse
Through “Drillings code” to 10 for NC HOP
Through “Drillings code” to 0 for TPA
Hope that helps,
Cheers, Alex
March 1, 2021
Hi
Is it possible to set up a fitting/rule that would automatically be set to a depth of “Through” if there was a corresponding hole the on the opposite face?
The attached screenshot is quite typical, these holes are for Blum drawers, Rafix 20 pins and door hinges, each hole is duplicated on both sides and are deep enough to go through.
This effectively doubles the CNC time and cost.
I’ve set up new Fittings for all these with a depth of Through and manually change them where required, can this be automated?
Thanks
1 Guest(s)