Avatar
Search
Forum Scope


Match



Forum Options



Minimum search word length is 3 characters - maximum search word length is 84 characters
Lost password?
sp_Feed sp_TopicIcon
Cut orientation for countertop
Avatar
Ness

Forum Posts: 1900
Subscriber Since:
October 4, 2012
Thanked 540 times in 1900 posts
Reputation: 23008
sp_UserOfflineSmall Offline
2
July 16, 2019 - 7:52 am
sp_Permalink sp_Print

Hi  Tom,

Grain on the work top is set to the cabinets depth.

If you set the grain direction to the width, it will rotate the part exported to OptiCut.

grain-angle.jpgImage Enlarger

Hope this is helpful,

Ness

sp_PlupAttachments Attachments

The following users say thank you to Ness for this useful post:

Tom Cleaver
Avatar
Tom Cleaver

Forum Posts: 103
Subscriber Since:
May 18, 2014
Thanked 4 times in 103 posts
Reputation: 621
sp_UserOfflineSmall Offline
1
July 12, 2019 - 8:17 pm
sp_Permalink sp_Print

Hi,

I have created a project with a countertop. The countertop has then been surface split to allow it to be made in two pieces. When exporting to Opticut it doesnt fit into the stock. From looking at the polyboard model the dimenions in the height and width should be swapped i.e the height should be the width, the width the height.

I can’t find a way to change this?

Project attached.

Forum Timezone: Europe/London
Most Users Ever Online: 256
Currently Online:
Guest(s) 1
Currently Browsing this Page:
1 Guest(s)
Top Posters:
terry: 253
mark nichols: 126
jimbouk: 105
Tom Cleaver: 103
Christopher Paré: 97
syslab: 97
Duayne Naugle: 83
Conor Devoy: 77
Jack Travis: 77
Rafal Meckovski: 62
Newest Members:
Chris Pinnick
diego andres flores hualpa
JOOST VAN WOR
Kathy Laird
James Lee
Alexandru Preda
Hilda Ferreira
Олександр Когут
Abraham Rai
Theo Ningiza
Forum Stats:
Groups: 2
Forums: 8
Topics: 1293
Posts: 7294

 

Member Stats:
Guest Posters: 4
Members: 113533
Moderators: 0
Admins: 9
Administrators: Ness, Stefan, michel melon, Carole Bosy, Alex, admin, Sunil Jaiswal, ipatrick, tempsimplead