Wood Designer forum
Edge Link Priority|Forum|WOOD DESIGNER
October 4, 2012
Hi Grover,
Sorry but there’s no way to tell the machinist which edges to do first.
For the information on straight or curved edging can you post a drawing of the different types of edge?
Best regards,
Ness
Ness said
Hi Syslab,I’m not sure I understand your question here.
If you split a panel using surface split you can apply edging to the edge between 2 parts. You have to tick the Individualise Division Parameters button:
If your photo show 2 cabinets side by side, then you can edge around the top by choosing the link to left and right sides.
Best regards,
Ness
Hello Ness,
Thank you very much for the prompt reply.
The client wants a guild to identify which is straight edge and corner round. The machine operator wants further details on what sides to be edged first. Is there a way to achieve these requests?
Thank you so much,
Grover
October 4, 2012
Hi Syslab,
I’m not sure I understand your question here.
If you split a panel using surface split you can apply edging to the edge between 2 parts. You have to tick the Individualise Division Parameters button:
If your photo show 2 cabinets side by side, then you can edge around the top by choosing the link to left and right sides.
Best regards,
Ness
1 Guest(s)