Log In
Home
November 8, 2013
Offline
Hi Deividas, the 2D DXF files are in the sub folders in that zip folder. We don’t offer a nesting optimisation or cutting optimisation service as part of the CabinetFile service. The best way to take a look at output from OptiNest or OptiCut is to go to the bottom of the download pages for each where you can download sample optimisations for testing. Hope that helps, thanks
September 14, 2018
Offline Deividas Galminas said
Hi again,
Thank you very much. I will check it
Hi,
I have few questions. Is it possible to get 2D DXF filse? And is it possible tu get cut plan, like for OptiNEst or OptiCut?
Looking forward for your answer.
September 14, 2018
Offline D-Alexandre said
hi again,here join your files
tel me if you need other or DXf adjust
All the best, Alexandre
(and sorry for my english)
Hi again,
Thank you very much. I will check it
The following users say thank you to Deividas Galminas for this useful post:
D-Alexandre
January 20, 2017
Offline hi again,
here join your files
tel me if you need other or DXf adjust
All the best, Alexandre
(and sorry for my english)
September 14, 2018
Offline D-Alexandre said
hi,could you confirm units using?
All the best, Alexandre
We using mm
January 20, 2017
Offline hi,
could you confirm units using?
All the best, Alexandre
September 14, 2018
Offline Hi,
I made first my PolyBoard project for test, before we will buy full this software version.
I want to ask you send for me CabinetFile (PDF workshop document, including the cut list and plans, plus DXF files).
17
1 Guest(s)
Usage Policy