Wood Designer forum
Libra H2 cabinet hanging system|Forum|WOOD DESIGNER
November 27, 2020
Offline
Ok think I somewhat get it now! And until I can look into it in more detail i have duplicated your settings and it worked perfectly 🙂
Thank you!
Moderator
January 20, 2017
Offline
Hi,
If I understand correctly, you used 37-n to refer to a non-priority pannel (Underpassing).
But here underpassing panel is cabinet back + Groove, the fitting are made from top at 37 less 10mm , 27mm
And you have to use 37mm of inner zone, conventional from top to bottom.
For the material,
the drillings assuming that the first hole is placed at 0 so at 37mm with the ruler no problem
For the shape
From the side panel, consider the recess as NO, you can check the tow option to see the difference in the starting references (red arrow).
From the top, from the right, centre at 37mm with the ruler minus 3mm to finish at 34mm.
X -3mm Y 19.5
Sorry for my english hope this is quite clear
Cheers, Alex
November 27, 2020
Offline
Sorry I don’t seem to be able to attach the screenshot of the dimensions, so here is a link to the image:
[Permission to view this media is denied]
November 27, 2020
Offline
Hello.
I have had a try at making the fitting link and rule for this Libra H2 cabinet hanger that we like to use.
After making a test cabinet I was very close but I think a bit off with the rule. Would it be possible to take a look at what i’ve done and show me where i’ve gone wrong?
1 Guest(s)
