Wood Designer forum
Panel Mortise & tenon|Forum|WOOD DESIGNER
Full
May 18, 2014
Offline
Hi All
We do this with drawers and also carcasses. Works well, but as you say, no way to split.
You have to also fiddle around with the groove tolerance in the post processor to get them tight.
Only panels you cannot do it to is ‘double backs’ as far as I can see.
We have also wanted to do this at times and never found a solution.
It would then also allow you to do a finger or comb joint if you added multiple gaps.
Moderator
January 20, 2017
Offline
Hi,
Sorry but it is not yet possible,
Cheers, Alex
Full
November 13, 2019
Offline
Hi, I am trying a new Mortise & tenon manufacturing method that is cut with a Nesting CNC only with outside boring but using screws to fix from the side. I think it would make assembly much faster.
I would like to split the mortise and tenon in the middle of the panel with a gape of +- 60mm. Is it possible? I’ve used inter tooling to split the tenon but need help with the mortise or is there is a other way to do it?
1 Guest(s)
