November 8, 2013
Hi again Dam,
Just to add to what Ness said...
The Alphacam team set up the macros we show in these videos: https://wooddesigner.org/alpha.....rdesigner/
They advised that since they are specific to each user, it is better to set them up yourself, with Alphacam's support if required.
October 4, 2012
I'm sorry but we don't know a lot about AlphaCam. In Polyboard we can show you how to setup the DXF layers to your requirement but for the AlphaCam setup you will have to ask your AlphaCam dealer.
The following users say thank you to Ness for this useful post:Dam Phan Tien
July 13, 2018