I applied the inner tooling to unit thanks for you help, i have another unit see attached i have the back split into panels on left and right, and the back if 70mm in from the left and right i want to screw these to each other top and bottom, but it is not letting me i must be missing something can you take a look
Thanks Caroline
Alex
Forum Posts: 1763
Subscriber Since: January 20, 2017
Offline
2
October 4, 2023 - 2:28 pm
Hi,
You have three solutions,
– First is with inner tooling, if you want to process the hole by milling
– Second, using the single panl fitting and single panel fitting libraries to do it with a drilling bit
I have attached a sink unit, we want to put a screw hole in back panel , 200mm up from bottom and 9mm in from left and right, can this be done seeing as there is nothing to attach to??