Wood Designer forum
sloped wardrobe |Forum|WOOD DESIGNER
Home
January 20, 2017
Offline
Hi Brendan,
-Firstly reproduice your skecth into cad to take needed dimension
-Offset each line to define the plinth, the base and the upper strip
-Divide or not your cabinet ( here you have to solution divide it on corner or in middle)
-take measurements of width and height and sloping from top
as you can see in the video, I did both solutions, but the second would be really impractical, but it gives you at least one idea with a multi-sloped top
The left-hand slope must be set to a negative value
Hope this helpful, Alex
May 12, 2020
Offline
Hi Alex
Yes that’s what we are looking for, just a few points please Can you allow for a plinth at the bottom 100mm up from floor, also if we had to do the same sloped wardrobe on the left hand side of the straight wardrobe can you show this.
Thanks for you help
January 20, 2017
Offline
Hi,
before making a video, did you have something like this in mind?
All the best, Alex
May 12, 2020
Offline
Hi
Attached is sketch of the wall we are looking to install 2 wardrobes one on the left will be full height, but how do we calculate the slope on the wardrobe on right. Need to minus 30mm left and right to allow for filler and up and down for plinths please send on video if possible
Thanks Brendan
1 Guest(s)
