Log In
Home
August 7, 2014
Offline
Hi Daniel
here is a fitting example
regards
Michel
August 7, 2014
Offline
Hi Daniel
this is obvious. You enter a flight length of 550 mm ?? this is 55CM . This is wrong .
The error is because your flight is shorter than the width of the second flight. So this is impossible.
You have to enter your dimensions properly
regards
Michel
May 19, 2021
Offline
Apologies it did not upload previously.
Also I have already subscribed to premium but when i click that link it takes me to a subscribe page.
August 7, 2014
Offline
Hi Daniel
This is the link to our stairplan service
https://wooddesigner.org/stair.....n-service/
Attach your stairfile in the post and explain what you want to do that is giving you an error.
regards
Michel
May 19, 2021
Offline
Also when i try design this myself there is an issue saying to parameter is not correct.
May 19, 2021
Offline
How do i request the stair plan?
August 7, 2014
Offline
Hi Daniel,
The forum is to assist you on the build of your stair and technical demands. We do not design your stair according to your data. This is another service which we call the stairplan and is a paying service.
So if you want it to be done via the forum you have to design your own stair and we can check if the technical aspect of the stair is ok and provide you documents if needed. ( stairfile docs 1 set of document free per month)
According to your CNC which uses a syntec controller. There is no specific output needed. A syntec controller processes only a gcode created with a cam software like v-carve who will produce your code. This is not done by stairdesigner unless you would use a CNC with native files like a Biesse or a felder machine.
regards
Michel
May 19, 2021
Offline
Hello I'm a new premium member and would like to request the design of a stair for a project, its to go in a tiny home.
Width 585
Floor Height 1670
First flight length approx. 550
Second flight approx 1070
Further id like to get the details of the output for my cnc running a syntec controller to make sure the Gcode works.
Thanks
1 Guest(s)
Usage Policy