Wood Designer forum
Newel Post and Tred Line Radius|Forum|WOOD DESIGNER
Moderator
January 20, 2017
Offline
Hi,
Unless I’m mistaken, the tread line is similar to that of the SD6,
(EDIT: image link no longer active)
The difference is now from SD7 you can be edit from both sides, and bisectrix
Cheers, Alex
Full
February 18, 2014
Offline
In that attachments you post you have a wide of the flight on 1000 mm, you have put tredline 100 mm from the right side. You get radius of 900 mm.
In Stairdesigner 6 you cold select a radius of for ex 350 mm anywhere you put the tredline.
In SD7 you only get the radius of where you put the tredline. In this case I put the tredline 400 mm from right side, I have 600 mm from left side to tredline, and I get 600 mm radius.
Moderator
January 20, 2017
Offline
Hi ,
Can you clarify what you means with “Tred Line Radius”, and if possible to make a quick drawing of what you need
But “Tred Line” can be moved by selecting flight
which will then modify the radius
Cheers, Alex
Full
February 18, 2014
Offline
what about tred line radius?
Moderator
January 20, 2017
Offline
Hi,
-You can deleted Newel post than place new intermediate Newel from line
– Can you clarify second point, because if you need a specific step with a different width from the others, for example, you will have to start the staircase with a landing.
Cheers, Alex
1 Guest(s)
