
August 7, 2014

Hi Michael
I have put square riser of 20 mm. This is set on the stringboards in cad. You can then easily find the midpoint for drilling the holes
regards
Michel


May 21, 2018

Hi Michel,
I have come to time to make this set of stairs and I have realised there may be something else Stairdesigner might be able to help with.
The stairs are to have 20mm stainless steel bars instead of risers, so I will need to add holes in the string boards, set back 25mm from the front edge of the treads, and halfway between the opening in between the treads. Obviously I could just add these in CAD on the square treads, but my geometry is not up to claculating the eliptical shape of the rod where they are on a tapered tread.
Is there a way you could add a steel rod instead of a riser, and then the shape of the rod would transfer onto the stringboards.
Im using your V2 version below..
Hope you can help!
Thanks
Mike


May 21, 2018


August 7, 2014

Hi Michael,
I have aligned the newels and added a step in the stair. This reduces the thread width still within regulations and gave the opportunity to have now step 8 straight and step 4. I enlarged the landing step to bring step 8 forward so that it connects with the newels.
Is this what you were looking for ?
Regards
Michel


May 21, 2018

Hi, how do I go about setting corner winders at right angles to one another. I realise it isnt always possible when trying to keep a stair as small as possible and still within building regs/stair rule, but on the stair I have attached, I have plenty of room in the goings, and I would like the newells on either side to be in line with one another. To do this I need riser 4, and riser 7 to be at right angles to the stringers.
Is there a way this can be done? I have tried move a step, but this doesnt seem to work.
Thanks
Mike
1 Guest(s)