Hi,

Just a few questions that have come up during our use so far:

How can we check the angle of the staircase?

Is there anywhere we can set the maximum and minimum angle in the control values for UK builidng regs?

Standard kite winders don’t meet the UK design regs. We need the internal corner of the kites to all meet in the newel posts. 

On the exterior perimeter where there is 2 sets of 3 winders at the bottom and top. We build the stringer into 3 pieces jointed together. In the cutting list it’s one whole piece. Can we set it up to be 3 separate pieces?

We bought the software mainly for the cutting list. But it does not give us sizes of each individual length or any angles for kites and steps. Stringers need to have the cut out sizes for each step cut-out measured onto the side of it. We do not CNC or print these lists. So we need every single measurement for all sides on the lists please. 

Thanks 

Alex