Wood Designer forum
Back Panel and Face Frames|Page 2|Forum|WOOD DESIGNER
Home
October 4, 2012
Offline
Hi Thusitha,
I can’t see all the files you have listed in your post but to answer your questions:
Yes, you can set back the back panel 3/4″ from the edge, this can be done in Lite and Pro.
Framing can be done in Pro but not in Lite.
All the Face Frame options you show are only active in Polyboard Pro.
The only images I can see in your post are a screen capture showing the Face Frame options in the Structures menu, I can’t see the images of your projects.
Can you upload them?
Otherwise from you description you should be able to do what you need with Polyboard Pro.
best regards,
Ness
November 8, 2013
Offline
Hi, we’ll reply in full as soon as possible. I know it’s urgent as you would like to upgrade from Polyboard Lite to Polyboard Pro.
I can only see 2 images attached though, which I think are the same as each other. Can you upload the other items you’ve referenced in your message. Thanks, Stefan
How are you? Hope you are doing good.
In the first attachment, we have shown the back panel of a cupboard. Back board is fixed three quarter of an inch inwards from the outer edge. Is it possible to do with Polyboard Pro?
In the second and third attachments we do the face frame, with two inch frame. In between the drawers we attach a 2.75 inch width piece. This enables us to do finger groves for the drawers.
In the fourth attachment, in your drop down list we have circled some options. Are they included in Polyboard Pro, or we have to add them?
We need your confirmation whether we can do all these with Polyboard Pro.
Hope to hear from you shortly.
Regards.
Thusitha.
1 Guest(s)
