

January 27, 2020


January 20, 2017

The following users say thank you to Alex for this useful post:
John Hosey
October 4, 2012

Hi Jose,
The problem with your model is that you are trying to add drawers in volumes that are created between the top and vertical divisions.
Polyboard can create sloping drawers between sloping sides but not between a sloping top and side or vertical division.
Here's and example of a unit where the sides have been sloped :
Because of this limit, the best way to build your unit is to create a project that assembles 3 separate units. Here is a screen capture of an example cabinet attached to this post:
As an example, I attach also the pdf print out of the Polyboard manufacturing document.
As you can see Polyboard will calculate all the cutting lists and part drawings of the unit and its drawers, as well as the CNC files if necessary.
The actual set up of the unit sizes will need some pre-planning so you might think of buying some training if you need help.
Hope this is helpful,
Best regards,
Ness
The following users say thank you to Ness for this useful post:
John Hosey

January 27, 2020


January 20, 2017

can you look at the video on this post first
https://wooddesigner.org/forum.....h-drawers/
polyboard needs parallel divisions with the bottom to add the drawers
let me now if you need more information
Cheers, Alexandre
The following users say thank you to Alex for this useful post:
John Hosey

January 27, 2020


January 20, 2017

hi,
can you send your project?
thanks, Alex
The following users say thank you to Alex for this useful post:
John Hosey1 Guest(s)