is there a reason it’s outputing like this on vcarve? Only a 6mm gap at the bottom and 6mm overhang at the top. Should be flush at top and 12mm gap at bottom for the shelf it’s overlapping..
Alex
Forum Posts: 1759
Subscriber Since: January 20, 2017
Offline
2
November 8, 2021 - 3:44 pm
Hi,
The only solution I see, is to create secondary materials that you exclude on the cut list, (Z-12mm)
Maybe with 100% transparency, and 2mm grooved instead of T&M
Any idea how i can add these optional divider slots or how i can get them to be marked but not necessarily cut out all the dividers (uprights). They appear to notch out about 2mm of the 12mm ply, to use the dividers where required.