Wood Designer forum
Grove into a single side of a piece|Page 2|Forum|WOOD DESIGNER
January 20, 2017
Offline
Hi,
Can you try this
All the best, Alex
October 3, 2022
Offline
I have sent you the file over email, afraid your solution has not worked yet.
January 20, 2017
Offline
Hi,
I’ll send you mail with information about this, should resolved this
Can you send me your cabinet?
Let me not if not
Cheers, Alexandre
October 3, 2022
Offline
I am in the process of designing a vanity unit and would like to include a cut out in the drawer to allow for the sink waste. I have done this with a double back, recessed from the sides of the drawer and 2 vertical divisions. I have having trouble removing the middle section of the back of the drawer, highlighted orange in the image below.
If I try to set it to a Nil Panel, the program thinks for a little bit then just reverts back to being a pine panel. Is this a bug?
If I remove it with an inner tooling it leaves a groove on both sides of the vertical divisions, see below.
We would like it so there is only a groove on the single side of the vertical divisions. How do I do this?
1 Guest(s)
