Wood Designer forum
Post processor|Forum|WOOD DESIGNER
Moderator
January 20, 2017
Offline
noted meeting at 14:30
Could be just at 2:30pm ? We gonna lunch now and we are back at that time.
Moderator
January 20, 2017
Offline
should it possible to look on session with Zoom? If yes i send you link by mail
hi,
we have already exported the furniture in pos processor B. And it is exchanging the right side with the left side, as shown in the images.
Moderator
January 20, 2017
Offline
can you upload you cabinet?
Did PolyBoard where on last version 7.08C?
If not the case
[Permission to view this media is denied]
You can download last version from this page
[Permission to view this media is denied]
After update can you make export with option B, and cabinet attached, and show me left side and right side
All the best, Alex
Hi,
see now if you understand. Otherwise the best would be to connect here to understand and show the problem.
Moderator
January 20, 2017
Offline
Sorry but i don’t understand when you said the left side is the right side?
Please create a cabinet with a single fixed shelf on top to see the difference.
Hi,
we have already tested option C. The drawer is still bad, as the tops continue to invert.
The side is correct because it is left.
Moderator
January 20, 2017
Offline
Can you test with this Option C B X mirrorring
and please upload your cabinet, thanks
Hi Alex,
we have already tested the two post processors.
In A, the pieces pass well, they pass in mirror but they are correct when we run the program, except for the side of the drawer where the tops are inverted, as shown in the attached image.
In option B, the holes all pass correctly, but pass as Not mirrored, that is, the right side is left.
1 Guest(s)
