Wood Designer forum
Shelf/rear double back - clash/error/bug (urgent)|Page 2|Forum|WOOD DESIGNER
February 22, 2021
Offline
Hi Michel,
that doesn’t seem like a solution really if i have to do that for every unit i design. It’s never done this before on my previous designs, which are the same set up. Can you ask dev team to look into it please?
Moderator
August 7, 2014
Offline
Hi Connor,
It seems the link is not working when overpassing the double back compared to the fixed shelf. The solution however is to select the fixed shelf and put a recess of the thickness of the double back in reference to the back.
Michel
February 22, 2021
Offline
See attached correct file (ref: rear double back/shelf clash)
February 22, 2021
Offline
Appologies, i’ve sent the incorrect PB file across! I will forward the correct version tomorrow to review.
Moderator
August 7, 2014
Offline
Hi Connor,
Is this the result you want to achieve?
regards
Michel
February 22, 2021
Offline
Hi Michel,
the double back at the front sits within the groove and adjusts the shelf, so the shelf sits 12mm further in so they don’t clash.
The double back at the back with red circle is doing the same. However, the shelf has not reduced by 12mm. So the double back won’t go on because the shelf comes past where the double back sits.
Moderator
August 7, 2014
Offline
Hi Connor,
This is not very clear to me. I do not see this in the PB file?
Can you be more specific?
regards
Michel
February 22, 2021
Offline
I have created a shelving unit today and only noticed when i cut it out that the rear double back has not reduced the shelf so it clashes. It’s not affected at the front, the shelf has been brought inside of the double back.
See attached file and image. Black circle area is fine, red circle is where the clash is.
The shelf needs to sit inside the recess like at the front.
Help?!
1 Guest(s)
