Wood Designer forum
fixed size treads |Page 2|Forum|WOOD DESIGNER
Moderator
August 7, 2014
Offline
Hi Duayne
You can set the steps as floating steps to get the ones near the winders corrected. Also, the steps on the second flight were not straight.
I corrected this and your tread width is now 10″.
The winder steps can also be set to floating to adjust them independently from each other.
I see you did not work with a landing step but extend the stringer length beyond the last step 4 inches. So that flight is 104 inches. Is that correct?
regards
Michel
Full
March 1, 2015
Offline
my file is 280 kb and can’t open it
Full
March 1, 2015
Offline
i would like to make all the treads in the drawing to be 10″ with a set of 3 winders at 90 degrees and 40″ wide , how do i go about that ?
I also have another set of plans that are basically the same but only have 2 winders , can’t seem to be able to do that !
1 Guest(s)
