Hi Dominique,

Here is a stair version on which I made changes to get it aligned as good as possible. I do not know all the details but look at it. I had to play with the shape of step 16 to meet step 19 and create the effect that on top of the stair, the handrail goes to the left as well as to the right. Where these 2 joints, you will need to manually an extra spindle to cle the balustrade properly.

There were some errors in elements which I have corrected. 

1 newel on step 2 is done. You can always move it to a better position using the properties screen

2 Scrolling the handrail at the start is not possible. Again this is a manual intervention in the build.

3 newel under the handrail is not possible yet in stairdesigner 

4 split is done as explained in my reply

Your pictures are too small, so I can not see them properly. 

Regards

Michel 

Hi Dominique,

The stair rule and read with are window parameters you can set in the tool menu under the control value. These parameters are ok, and the red figure is slightly below the limit. I would not bother about that 

regards

Michel